| December 28, 2002 | ||||||||||
|
|
|||||||||
| Jig used to taper shear clamps so two lengths can be scarfed together. | 1" X 1 1/2" shear clamps are made by laminating 7/8 cedar then scarfing short pieces together. | |||||||||
|
|
|||||||||
| Because of the cold snap, the scarfed shear clamps are raised up near the ceiling where the temperature is around 75f. Epoxy sets up much faster. | Ribs bent and set in. | |||||||||
|
|
|||||||||
| Ribs are cut 1 1/2" below the shear. | ||||||||||
|
|
|||||||||
| Dry fitting shear clamp. | Laminated cedar block used for mast step. | |||||||||
| HOME | ||||||||||